Remove the screws holding the thermostat and high limit switch from housing.Do not remove the wire harnesses from the thermostat or high limit switch.Disconnect the wire harness from the heating element.Pull heating element housing out of the dryer.Remove screws that hold mounting bracket to the base.Remove screw that holds the heating element housing.Disconnect the moisture sensor wiring harness.Depress the locking tabs and remove the front panel.Open dryer door and remove 2 more screw at the base of the door.Remove 4 screws that secure the front panel.Remove wire harness holding the control panel to the dryer.Remove the control panel off by lifting upward.Remove the screws on the back of the dryer.Samsung Dryer Heating Element DC47-00019A How to remove and replace Samsung dryer heating element? If you have tested ALL aspects of the dryer and have found that the heating element is what is faulty, here is how to replace it. When your Samsung dryer will not heat, BE SURE YOU HAVE CLEANED THE VENT LINES AND LINT FILTER as a clogged vent line will cause your Samsung dryer to NOT HEAT properly.Ĭheck all parts of the dryer to be sure what is causing it NOT HEATING.Ĭheck thermostats, thermal cut off fuse, wiring, voltage, and vent line. Samsung Dryer Runs But Will Not Heat What can cause Samsung Dryer to not heat? ![]() ![]() NOTE: If your Samsung Dryer is getting an error code, check here for Samsung Dryer Fault Codes. The Samsung dryer may have a bad thermostat, thermal cut out fuse, clogged air vent line, incorrect voltage, faulty heating element, or other internal wiring issues. However, you need to do some further testing to be sure the element is causing your Samsung dryer to not heat. A bad element on Samsung dryers is quite common with some of the newer dryers. If your Samsung dryer will spin but will not heat, a burnt heating element could be your issue.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |